D - Dial Command - Westermo TDW-33 Commands Interface Manual

D – Dial command
Supported by:
TDW-33
Description:
The ATD command is used for data or fax call.
For a data or a fax call, the application sends the following ASCII string to the product:
ATD<nb> where <nb> represents a dial string composed of dial characters and
dial modifiers.
The dial characters include the decimal values 0 through 9, letters A,B,C,D, and the
symbols "*" and "#".
Dial modifier description:
Separator Name
, Commaseparator
$ Bongtonesepator
; Returncmdseparator
/ waitsepator
: PABX
+ Insert shortkey
? Delimiter
W Wait
= Secdialsep.
& Wait for credit card
dialing tone
@ Quietseparator
L RE-dial
last dialed number
P Select pulse dialing
\ Select pulse dialing
T Select Tone dialing
S = n Dial Stored Number
! Flash
8 8
TD-36 TD-36 485 TR-36
Functionality
Insert a pause in dialing procedure
A bong tone needs to be detected before
dialing continues
Return to command state
Waits for 0.125 seconds
Wait for PABX tone
Delimiter between number to be dialed (P#)
and PSTN security access password
Wait for dial tone before processing to next
character in the dial string
Wait for second dialtone
Wait for credit card dialing tone before
continuing with the dial string. If the tone is
not detected within the time specified by S6
or S7, the modem will abort the rest of the
sequence, return on-hook, and generate an
error message.
Wait for second dialtone
The L must be immediately after the D with
all characters ignored.
Pulse dial the numbers that follow until a "T"
is encountered.
Pulse dial the numbers that follow until a "P"
is encountered.
Dial the number stored in the directory
n = 0 to 3
The modem will go on-hook the time
specified in S29.
6618-3201