Wn - Connect Message Control - Westermo TDW-33 Commands Interface Manual

Wn – Connect message control
Supported by:
TDW-33
Description:
This command controls the format of CONNECT message.
This command can be overide by ATS95 and AT\V commands.
Syntax:
ATW<n>
Parameters:
<n>
0: Upon connection, the modem reports only the DTE speed.
1: Upon connection, the modem reports the line speed, the error correction protocol,
and the DTE speed respectively.
2: Upon connection, the modem reports the DCE speed
Command example
ATW
S register: The value is written to S31 bits 2 and 3.
&Wn – Store system setting
Supported by:
TDW-33
Description:
This command saves the current (active) configuration (profile), including S-Registers,
in one of the two user profiles as denoted by the parameter value.
Syntax:
AT&W<n>
Parameters:
<n>
0: Store the current configuration as profile 0
1: Store the current configuration as profile 1
Command example
AT&W<n>
S register: None
6618-3201
TD-36 TD-36 485
Possible responses
OK
ERROR
TD-36 TD-36 485
Possible responses
OK
TR-36
TR-36
Note
<n> = 0,1,2
Otherwise
Note
Writes configuration
<n> to EEPROM
35 35