Remove And Replace The Ssd - Cisco Firepower 2100 Series Hardware Installation Manual

Remove and Replace the SSD

Figure 47: Remove the Network Module
If the slot is to remain empty, install a blank faceplate to ensure proper airflow and to keep dust out of the chassis;
otherwise, install another network module.
Step 4
To replace a network module, hold the network module in front of the network module slot on the right of the chassis
and pull the network module handle out.
Step 5
Slide the network module into the slot and push it firmly into place until the handle is flush with the front of the network
module.
Step 6
Tighten the captive screw on the lower left side of the network module.
Step 7 Power on the chassis so that the new network module is recognized.
What to do next
Follow the procedures in the
it has been discovered correctly by the security appliance.
Remove and Replace the SSD
Take note of the following warnings:
Warning
Statement 1030 Equipment Installation
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Cisco Firepower 2100 Series Hardware Installation Guide
66
FXOS configuration guide to connect to the network module and make sure that
Maintenance and Upgrade