Cisco Firepower 2100 Series Hardware Installation Manual page 16

Front Panel LEDs
11 Ethernet Speed
• Green, flashing—The number of flashes
The following figure shows the Firepower 2130 and 2140 front panel LEDs.
Figure 8: Firepower 2130 and 2140 Front Panel LEDs
1 Power
• Off—Input power is not detected. Standby
• Green, flashing—The system has detected
• Amber—The system is powering up (before
• Green—The system is fully powered up.
Cisco Firepower 2100 Series Hardware Installation Guide
12
determines link speed; 1 flash=10 Mbit,
2=100 Mbit, 3=1 Gbit.
power is off.
a power switch toggle event, and initiated
the shutdown sequence. If the power switch
is in the OFF position, the system powers
off after shutdown is completed. Do not
remove the AC or DC power source while
this LED is blinking so that the system has
time to perform a graceful shutdown.
the BIOS boots). This takes one to five
seconds at most.
12 Fiber Port
• Green—Port is enabled, the link partner is
detected.
• Amber—Port is enabled, but the link partner
is not detected.
• Green, flashing—Port is enabled; network
activity is detected.
2 Locator LED
• Off—Locate is off.
• Blue—Locate is on.
The Locator beacon helps you locate
Note
a unit that needs physical service
attention. This feature is activated in
the software.
Overview