Remove And Replace The Ssd - Cisco Firepower 2100 Series Hardware Installation Manual

Hide thumbs Also See for Firepower 2100 Series:

Table of Contents

Installation, Maintenance, and Upgrade

Figure 47: Remove the Network Module

If the slot is to remain empty, install a blank faceplate to ensure proper airflow and to keep dust out of the chassis;

otherwise, install another network module.

Step 4

To replace a network module, hold the network module in front of the network module slot on the right of the chassis

and pull the network module handle out.

Step 5

Slide the network module into the slot and push it firmly into place until the handle is flush with the front of the network

module.

Step 6

Tighten the captive screw on the lower left side of the network module.

Step 7

Power on the chassis so that the new network module is recognized.

Remove and Replace the SSD

Although the hardware supports removing and replacing SSDs while the system is running, the software does

not currently support hot swapping. You must power down the chassis to remove and replace SSDs.

Note

The 100-GB SSD is restricted to the 2110 and 2120 models. The 200-GB SSD is restricted to the 2130 and

2140 models. Do not mix them.

You can install a Malware Storage Pack (MSP) in slot 2. The MSP stores threat detection data for use in future

analysis. It supports the Advanced Malware Protection (AMP) software feature. It is used as both storage and

as the Malware application repository. RAID is not supported.

Cisco Firepower 2100 Series Hardware Installation Guide

Table of Contents