Cisco Firepower 2100 Series Hardware Installation Manual page 65

Mount the Chassis
Figure 44: TELs Placement on the Chassis
1 TEL
3 TEL
5 TEL
7 TEL
Step 8 Attach the power cable to the chassis and connect it to an electrical outlet.
Step 9
Press the power switch on the rear panel.
Step 10 Check the power LED on the front panel. See
indicates that the chassis is powered on.
Step 11 Place the chassis in FIPS mode.
See the following procedures for how to place the chassis in FIPS mode:
• ASA in Platform Mode
• ASA in Appliance mode
• FTD managed by FMC
What to do next
See the quick start guide for your operating system for further configuration information.
Install the FIPS Opacity Shield in a Four-Post Rack
2 TEL
4 TEL
6 TEL
Front Panel LEDs for a description of the power LED. Solid green
Cisco Firepower 2100 Series Hardware Installation Guide
61