Maintenance And Upgrade; Remove And Replace The Network Module - Cisco Firepower 2100 Series Hardware Installation Manual

Hide thumbs Also See for Firepower 2100 Series:
Table of Contents

Advertisement

Maintenance and Upgrade

Remove and Replace the Network Module

Take note of the following warnings:
Warning
Statement 1030 Equipment Installation
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1073 No User-Serviceable Parts
No serviceable parts inside. To avoid risk of electric shock, do not open.
You can remove and replace the network module in the Firepower 2130 and 2140. Although the hardware
supports removing and replacing the network module while the system is running, the software does not
currently support hot swapping. You must power down the chassis to remove and replace network modules.
See
Network Modules, on page 16
Step 1
Save your configuration.
Step 2
Power down the appliance by moving the power switch to the OFF position. See
information about the power switch.
Step 3
To remove a network module, loosen the captive screw on the lower left side of the network module and pull out the
handle that is connected to the screw. This mechanically ejects the network module from the slot.
Remove and Replace the Network Module, on page 65
Remove and Replace the SSD, on page 66
Remove and Replace the Power Supply Module, on page 68
Connect the DC Power Supply Module, on page 70
Secure the Power Cord on the Power Supply Module, on page 74
Remove and Replace the Fan Tray, on page 76
C H A P T E R
for more information about Firepower network modules.
Cisco Firepower 2100 Series Hardware Installation Guide
4
Rear Panel, on page 14
for more
65

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents