Cisco Firepower 2100 Series Hardware Installation Manual page 29

Overview
Table 6: DC Power Supply Module Hardware Specifications
Input voltage
Maximum input current
Maximum output power
Redundancy
Efficiency
Power Supply Module LEDs
The following figure shows the bicolor power supply LEDs on the power supply module. The figure shows
the AC power supply module. The DC power supply module has the same LEDs.
Figure 15: Power Supply Module LEDs
1 Amber FAIL LED
The following describes the power module supply LEDs.
Green LED (OK Status)
• Off—Input power not present.
• Green, flashing—Input power present, but system is not powered up (power switch is off).
• Green—The power supply module is enabled and running.
Amber LED (Fail Status)
• Off—No fault detected.
2130
-48 to -60 V DC
< 15 A at -48 V
The power supply module is rated at 15 A but the system
Note
power is limited to 6.1 A. See
page 30 for more system specifications.
350 W
1+1 redundancy with dual power supply modules
> 88% at 50% load
2 Green OK LED
Cisco Firepower 2100 Series Hardware Installation Guide
Power Supply Modules
2140
Hardware Specifications, on
25