Secure The Power Cord On The Power Supply Module - Cisco Firepower 2100 Series Hardware Installation Manual

Secure the Power Cord on the Power Supply Module

Secure the Power Cord on the Power Supply Module
To secure the power supply module against accidental removal and thus prevent disrupting system performance,
use the tie wrap and clamp provided in the accessories kit that ships with your Firepower 2100.
Take note of the following warnings:
Warning
Statement 1030 Equipment Installation
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1073 No User-Serviceable Parts
No serviceable parts inside. To avoid risk of electric shock, do not open.
Step 1 Attach the clamp to the tie wrap by holding the clamp with the loop side on the bottom and sliding the tie wrap through
the box-shaped channel above the clamp (see the following figure).
One side of the tie wrap has evenly spaced ridges and the other is smooth. Be sure the ridged side is face up and that you
slide it through the open side of the channel. You will hear a click as the tie slides through—it moves in one direction
only. To remove the tie wrap from the clamp, push the lever on the closed side of the box-shaped channel and slide out
the tie wrap.
Figure 53: Tie Wrap Through the Box Channel of the Clamp
Box channel
1
Step 2
Attach the clamp to the power supply module:
a) Locate the hexagonal ventilation hole on the power supply module at the center of the plug just below the power
connector body (see the following figures).
Cisco Firepower 2100 Series Hardware Installation Guide
74
Tie wrap
2
Maintenance and Upgrade