Electromagnetic Compatibility (Emc) - Maico easyScreen Operation Manual

WARNING
WARNING
WARNING
WARNING

2.7 Electromagnetic Compatibility (EMC)

WARNING
WARNING
8508935 Rev. 4
Operation Manual easyScreen
The device is not intended for operation in areas with an
explosion hazard. Do NOT use the device in a highly
oxygen-enriched environment, such as a hyperbaric
chamber, oxygen tent, etc. If the device is not used switch it
off and disconnect it from the power supply.
Never short-circuit the terminals.
To avoid the risk of electric shock, this equipment must only
be connected to the medical power supply originally
delivered by MAICO. Using another power supply can also
lead to electrical damage on the device.
Prevent cable breakage: cables must not be bend or buckled.
Before performing any service to the insert earphones, such
as disconnecting the transducer boxes from the cable, you
must uncouple the easyScreen transducers and electrodes
from the patient.
Do not open the case of the easyScreen device. Refer
servicing to qualified personnel.
The device fulfills the relevant EMC requirements. Avoid
unnecessary exposure to electromagnetic fields, e.g. from mobile
phones etc. If the device is used adjacent to other equipment it
must be observed that no mutual disturbance appears.
Please, also refer to EMC consideration in section 6.5.
The easyScreen has been verified by an independent laboratory
to conform to international standards for EMC (electromagnetic
emissions and immunity). The user is advised to avoid installation
and use of this device in proximity with other devices or
equipment that may emit or be susceptible to electromagnetic
interference, including mobile phones. If the device is used
adjacent to other devices or equipment, the user is instructed to
verify that no disturbance is found in the operation of this or other
equipment in proximity.
15 04/04/2019