Siemens SINAMICS S120 Manual page 44

Entering limit values for safely limited speed (sls) into a sinamics s120 via profisafe with profinet

Hide thumbs Also See for SINAMICS S120:

Table of Contents

4 Configuration and project engineering

No.

Action

Then select DI3 (r722.3) as

signal source for the test stop of

the safety functions.

This means that the test stop

can be controlled using switch -

S8.

Now press the "PROFIsafe

configuration" button.

In the PROFIsafe configuration,

enter the PROFIsafe address

that you defined in HW Config.

Address "C6hex" is used in this

example.

Then check that the PROFIsafe

telegram of "Telegram

configuration" matches the

"Safety parameterization".

Close the window by clicking

"Close".

Please press the "Safe stop

functions (SS1, SS2, SOS,

SAM)" button to configure the

SS2 safety function, which

becomes active when the SLS

limit value is exceeded.

Remark

PROFIsafe SLS Override

Version 1.0, Entry ID: 81682475

Table of Contents