Uplift Desk V2 Height Adjustable Bamboo Conference Table Assembly Instructions Manual page 7

Step 7
Once all components are in place and aligned as
shown, attach each Crossbar end to its Main table
section using one #10-24x3/4'' Machine screw (H4b)
and one Washer (H5).
Make sure each screw is started but do not complete-
ly tighten until Step 8. Rotate each screw by hand for
only a few turns to avoid cross-threading.
Step 8
Make sure that the table top sections are as close
together as possible with no visible gaps and that
the side edges are aligned. Also, be sure that there
is nothing caught between the table top sections
like carpet or blanket material.
Align each of the three Support brackets (C9) as
shown.
Insert six #10-24x3/4" Machine screws (H4b) and
six Washers (H5) in each Support bracket. Rotate
each screw by hand for only a few turns to avoid
cross-threading.
Once all screws from Step 7 and Step 8 are start-
ed, finish tightening all 18 screws. Be careful to not
overtighten screws, as this could cause the threads
on the Machine screws to become stripped.
H3
Step 9
Slide each Crossbar rail (C3) until the Center indicator
mark is at the center of the Table assembly. Once this
is done, the Crossbar rail will be centered and in the
proper position.
Insert four M8x8 Set screws (H3) into the holes on
each Crossbar end and tighten using the 4mm Allen
wrench (H6).
Step 10
H14
Choose where you'd like your Keypad to be mounted.
H14
Remember that you're assembling your table upside
down, so the final location of the Keypad will be op-
posite of what you're seeing during assembly.
C6
At each corner, there are two sets of holes to accom-
C6
modate different Keypads. Line up your Keypad (C6)
with the appropriate pre-drilled holes and attach it to
the table top with two #10x5/8'' Wood screws (H14).
7
© UPLIFT Desk • 800-349-3839 • 512-614-3152 • info@upliftdesk.com • upliftdesk.com