Uplift Desk V2 Height Adjustable Bamboo Conference Table Assembly Instructions Manual page 9

fig. 1
fig. 2
fig. 3
© UPLIFT Desk • 800-349-3839 • 512-614-3152 • info@upliftdesk.com • upliftdesk.com
Step 13
Double check that all accessible screws on the table
are secure and not loose.
And then check all screws again and make sure they're
tight. This isn't a typo, it's important and it's far easier
to tighten them with the table upside down than it is
later.
We're pointing out all the screws to check in this dia-
gram.
Step 14
In order to avoid injury, or damage to your new ta-
ble, we STRONGLY recommend that no fewer than
four people flip the Table upright.
To flip the table over, position two people, evenly
spaced, along the long side of the table that has the
Keypad attached to it. The other two people should
position themselves on the short sides of the table, at
the corners nearest to the other two people (see fig 1).
With all four people lifting at the same time, raise the
table gently until it is perpendicular to the floor, with
the keypad facing up.
The two people who were on the long side of the
table can now move to the ends of the table. The
other two people can begin to ease the table legs
down towards the floor while supporting both the
frame and the tabletop (see fig. 2).
As the legs on the long side opposite the keypad
make contact with the floor, the two people origi-
nally positioned on the keypad sideshould grab a
hold of the corners near the floor and help support
the table, to avoid putting undue stress on the legs
(see fig. 3).
All four people can now continue to lower the table
until all four legs are on the floor.
9