Station Hunting; Step Call - NEC UNIVERGE SV9100 DT930 User Manual

1.
It is required that the dedicated feature key
other than fixed feature key (Hold) be set by
system data setting at initial installation.
For details, contact the system administrator.
(1) While call in progress, the Line key lamp lights
red.
(2) Press Hold.
The Hold lamp does not light.
The called party receives a hold tone.
(3) To make a call to another party or answer the
incoming call, replace the handset after finishing
a call.
(4) The original call rings back.
The Call Indicator Lamp flashes.
The Line key lamp flashes green.
(5) Lift the handset to restart a conversation.
The Line key lamp lights green.

Station Hunting

When a busy terminal that is assigned a Station
Hunting pilot number is called, this feature permits the
incoming call to be routed to another telephone within
the hunt group.
The telephone that is assigned the Station
Hunting feature and the pilot number are set
by system data setting at initial installation.
For details, contact the system administrator.
You cannot set Call Back, Call Waiting or
Executive Override to the pilot number of the
hunt group.
(1) Lift the handset.
(2) Dial the desired number.
If the pilot number is busy, the call is routed to
another telephone within the hunt group.
(3) Start a conversation with called party.

Step Call

This feature allows the terminal user, after calling a
busy terminal, to call an idle terminal by simply dialing
an additional digit. .
The feature key is set by system data setting at
initial installation.
For details, contact the system administrator.
(1) Lift the handset.
The Line key lamp lights green.
(2) Dial the extension number.
You receive a busy tone.
(3) Enter the specific digit.
You can randomly select the last digit of the
extension number from 0~9.
72