Call Pickup - Group; Call Pickup - Direct; Multiline Appearance - NEC UNIVERGE SV9100 DT930 User Manual

1.
When you make a call handsfree, note the
following items.
❍
Avoid using in a place where there is a lot
of echo or noise.
❍
The Microphone is located at the front of
the terminal. It should be no further away
than 50 cm (19.69 inches).
❍
When talking handsfree, be aware of the
volume level so you do not disturb people
close to you.
❍
Talk alternately with the other party. The
voice may be interrupted if both party talk
at the same time.
Call Pickup – Group
This feature permits users to answer any calls directed
to other extensions in their preset pickup group.
This feature is set using a Softkey or Feature
key. The Feature key is set by system data
setting at initial installation.
For details, contact the system administrator.
(1) When the telephone in you pickup group rings,
press the Speaker key.
The Speaker key lamp lights red.
↓
(2) Press .
(3) Press P/U.
(4) Press P/U.
(5) Start the conversation with the calling party.
Call Pickup – Direct
This feature permits a terminal user to pickup a call to
any other terminal in the system.
The Feature key is set by system data setting at
initial installation.
For details, contact the system administrator.
(1) Press the Speaker key.
The Speaker key lamp lights red.
**
(2) Press .
The Speaker key lamp lights red.
(3) Dial the extension number of the telephone that is
ringing.
(4) Start a conversation with calling party.

Multiline Appearance

This feature allows you to accommodate the lines
(another terminal number) other than My Line on the
Programmable line/feature keys.
When accommodating another terminal number on the
programmable line/feature key, you can answer the call
routed to another by pressing the key that is assigned.
The Feature key is set by system data setting at
initial installation.
For details, contact the system administrator.
68