ProLights SUPERFLOWER DMX led User Manual page 22

10
3.9 Remote control EC800 (optional)
The remote control EC800 (Fig. 2) available as an accessory allows to control different functions:
1. Connect the remote control to the jack ONLY FOR REMOTE CONTROL (9).
2. No DMX signal must be present at the DMX INPUT (10).
3. At DMX can be connected to other movements SUPERFLOWER remote synchronized with the main unit.
4. With the key STAND BY (17) you can activate and deactivate the light rays. If the feature is turned off for
a check, the LED next to the button lights up.
5. With the button MODE (15), select the operating mode:
a) Stroboscope mode SOUND (LED next to the button MODE does not light up).
Each time the button FUNCTION is kept pressed, the unit changes to the next of the three strobosco effects:
- Strobosco effect permanent;
- Strobe effect 2 LIGHT SHOW;
- Strobosco effect depends on the music.
b) Show mode (LED ON).
With the FUNCTION button (16) you can select show 1-12.
NB The length of the cable remote EC800 is 10 m.
- 4 - MAINTENANCE
4.1 Cleaning the unit and maintenance
• Make sure the area below the installation place is free from unwanted persons during set-up.
• Switch off the unit, unplug the main cable and wait until the unit has cooled down.
• All screws used for installing the device and any of its parts should be tightly fastened and should not be corroded.
• Housings, fixations and installation spots (ceiling, trusses, suspensions) should be totally free from any deformation.
• When the lens is visibly damaged due to cracks or deep scratches, it must be replaced.
• The main cables must be in impeccable condition and should be replaced immediately even when a
small problem is detected.
• In order to protect the device from overheating the cooling fans (if any), and ventilation openings should
be cleaned monthly.
• The interior of the device should be cleaned annually using a vacuum cleaner or air-jet.
• It is recommended to clean the plastic panel of the unit at regular intervals, from impurities caused by
dust, smoke, or other particles to ensure that the light is radiated at maximum brightness. For cleaning,
disconnect the main plug from the socket. Use a soft, clean cloth moistened with a mild detergent. Then
carefully wipe the plastic pane dry. For cleaning other housing parts use only a soft, clean cloth. Never
use a liquid, it might penetrate the unit and cause damage to it.
Warning: we strongly recommend internal cleaning to be carried out by qualified personnel!
SUPERFLOWER