ProLights SUPERFLOWER DMX led User Manual page 18

6
- 3 - FUNCTIONS AND SETTINGS
3.1 Operation
Connect the supplied main cable to a socket (230 V~/50 Hz). Then the unit is ready for operation and can
be operated via a DMX controller or independently display its show programme in succession. To switch off,
disconnect the main plug from the socket. For a more convenient operation it is recommended to connect
the unit to a socket which can be switched on and off via a light switch.
3.2 Set-up
The following basic adjustments can be made via the display (3) and the control buttons (5). Press the but-
ton MENU so many times until the desired function is indicated. Then press the button ENTER. Make sure
that the next button is pressed within 10 seconds, otherwise the adjusting process will end automatically.
Adjustment of the start address:
10/4-channels DMX mode:
Mode MASTER/SLAVE
Use the button DOWN or UP to select (6):
To memorize, press the button ENTER.
Show mode:
Blackout mode on or off (This menu item is only available in the MASTER mode.)
Use the button DOWN or UP to select (6):
Display ON or OFF
Use the button DOWN or UP to select (6):
Display representation
Use the button ENTER to select and
memorize at the same time:
Approx. 10 s after pressing the last button, the adjusting menu is exited automatically.
Working hour meter (fixture hours). After pressing the ENTER button, the display will show the working hours.
To return to the previous operating mode, press the MENU button. The next menu item will flash for 8 seconds.
Then the menu will disappear.
To display the version number of the firmware (operating system of the light effect unit).
SUPERFLOWER
. . .
10 channels
4 channels
The operating mode MASTER must be selected for operation
without a DMX controller when the unit is used on its own or
used as a master unit to control further slave units.
The operating mode SLAVE 1 must be selected for operation
without a DMX controller when the unit is used as a slave unit
to be controlled in sync with the master unit.
The operating mode SLAVE 2 must be selected for operation
without a DMX controller when the unit is used as a slave unit
to be controlled by the master unit, but its effects are to be
opposite to the effects of the master unit.
show 0
show 1
. . .
show 12
. . .
The LEDs are permanently on. This adjustment must be selected
when the unit is operated without a DMX controller.
The LEDs only light up when there is a DMX control signal at
the jack DMX INPUT. Once the DMX controller is switched off,
all LEDs will go out.
The display (3) is always on.
The display is switched off approx. 60 s after pressing the last
button. It is switched on again the next time a button is pressed.
Normal representation.
Representation turned by 180°.