Maxxus 4.2 Installation & Operating Manual page 6

Assembly
Carefully unpack all parts of the delivery. Two people are required because some parts of your training device
are bulky and heavy. Before starting the assembly, check the completeness of the fixing materials (screws, nuts,
etc.) and the components against the parts and fixing material lists on the previous pages of this manual.
Carefully carry out the installation, as damage or defects that have arisen due to assembly errors are not
covered by the warranty under any circumstances. Read the instructions carefully before starting, follow the
sequence of the installation steps exactly and follow the instructions for the individual assembly steps. The
installation of the training device must be carried out by responsible adults.
Carry out the installation of your training device with two adults in a location that is level, clean and free of
obstruction during assembly. Only after assembly of the training device has been completed can training be
started.
Step 1: Assembling the Rear Stand
Attach the rear stand (C) with two 3/8" hexagon bolts (2), four 3/8" washers (1), and two 3/8" cap nuts (8) to the
rear mounting of base frame (A).
8
C
A
1
2
6