Maintenance Work - Wacker Neuson IEC Operator's Manual

11.3

Maintenance work

WARNING
A damaged machine part, protective hose or power cable can result in personal injury
caused by electric current.


Working in the workshop
Perform maintenance work in a workshop on a workbench. This has the following benefits:
Protection of the machine of contamination on the construction site.

A level and clean work surface makes work easier.

There is a better overview over small parts and they are not lost as easily.

Checking the wear dimensions of the vibrator head
Wear dimensions:
Minimum diameter of lower tube øL

Minimum diameter of vibrator head øL at measuring point L

Length of vibrator head L

Wear is highest at the end of the vibrator head.
Let the vibrator head be exchanged by your Wacker Neuson contact if the wear dimensions are reached
at a certain point.
The vibrator head assembly must be replaced by the service department of the Wacker_Neuson contact
partner.
Machine
type
IEC38
IEC45
IEC58
Dimensions in bold are wear dimensions.
Dimensions in brackets are original dimensions of new machines.
100_0101_mt_0018.fm
Do not operate a damaged machine.
Have a damaged machine repaired immediately.
L
Dimensions for vibrator head and lower tube [mm]
øL L
L L
33 (38) 275 (285)
38 (45) 315 (327)
50 (58) 390 (400)
L
øL L
35 (38) 180
42 (45) 194
54 (58) 205
11 Maintenance
25