Electrical Connection - EMG ELDRO EdEx Series Assembly Manual

6.2

Electrical connection

ELDRO-EdEx-Montageanleitung-607338-EN.docx
DANGER
Live components
Fatal electric shock or serious burns
– Work on live components may only be performed by
electricians.
– When performing any work on electrical components, the five
safety rules must be adhered to:
– 1. Disconnect from the electrical supply
– 2. Safeguard to prevent a restart
– 3. Test to ensure a de-energised state
– 4. Earth and short-circuit
– 5. Cover or isolate adjacent live parts
– The earthing conductor must always be connected before all
other cables.
– Electrical power may only be supplied once the earthing
conductor is connected.

Standard requirements must be observed when connecting the
EdEx thruster.

Before connecting, check whether the mains voltage and the
mains frequency correspond to the specifications on the type
plate.

When selecting the connection cable (temperature resistance),
an excess temperature of +40 K to the ambient temperature
must be taken into account.

For cable entries (temperature resistance) an excess
temperature of +35 K to the ambient temperature must be taken
into account.

If there is a risk of mechanical damage, the cable must be
additionally protected (e.g. with a protective tube).

The cable diameter must be observed to ensure a tight
connection in the cable entry.
Assembly and installation
Electrical connection
6
6.2
47 / 75