EMG ELDRO EdEx Series Assembly Manual page 46

6 Assembly and installation
6.1 Assembly
46 / 75
Process
To attach the EdEx thruster, there are fastening eyelets on the motor
housing and holes in the lifting rod, which can be used with suitable
bolts to establish the connection to the equipment to be operated
(e.g. brakes).
The diameter and length of the required bolts are specified in the
dimension tables (⇒Technical data chapter, Dimensions section).
When selecting or measuring the bolts (by the operating
company) the required pivoting ability of the EdEx thruster must
be observed.
The EdEx thruster is installed in the following steps:
 Use lifting gear to move the EdEx thruster to the installation
location.
 Grease the bolt slightly in order to prevent it rusting tight.
 Insert the bolt into the foot hole.
 Insert the bolt into the thrust shackle hole.
NOTICE
Both bolt axes must be parallel as otherwise, the lifting rod jams
and the thruster's free power development is not guaranteed.
 Use cotter pins or similar to secure the bolts to prevent them
slipping out
ELDRO-EdEx-Montageanleitung-607338-EN.docx