EMG ELDRO EdEx Series Assembly Manual page 44

6 Assembly and installation
6.1 Assembly
44 / 75
CAUTION
Sudden power failure or switch-off due to any C-springs,
brake springs, brake weights that may be installed or due to
other external influences
Risk of crushing due to the lifting rod.
– The downstream drive must be secured before removing the
EdEx thrusters, because the lifting rod retracts automatically.
NOTICE
The lifting rod must not be damaged or contaminated,
e.g. by paint as a result of painting the entire system. A failure to
observe this will destroy the lifting rod.
NOTICE
The fastening bolts on the foot hole and the lifting rod must be
secured reliably to prevent them slipping out (e.g. using cotter
pins).
NOTICE
The EdEx thruster must not be subjected to any loads at an angle
to its working direction. If installed upright, there must be no
additional load beyond its own weight.
When replacing old EdEx thruster versions with thrusters of the
current type series, it is necessary to contact the manufacturer
due to the different installation dimensions (⇒ General chapter,
Manufacturer section).
ELDRO-EdEx-Montageanleitung-607338-EN.docx