Table of Contents
Advertisement
Chapter 4 Operation
4.2.1.2 Alarms
To display an Alarm status:
From the Display menu use the UP (↑ ↑ ↑ ↑ ↑ ) or DOWN (↓ ↓ ↓ ↓ ↓ ) button to highlight Alarms and press the ENTER
button. The display will show the status of the alarms. If no alarms are present, the display will show "NO
ALARMS". If more than one alarm is active, the display will cycle through all active alarms. If the Alarm
check option is turned off, this will be indicated on the display as "ALM CHKS OFF".
NOTE: To have the Alarm information come up automatically at power up and be the default display, use
the PROGram, Displays, Powerup disp option to set Alarms as the Powerup display default.
Refer to Section 5.4.3.
4.2.1.3 Junction Temp
To display Cold Reference Junction Temperature:
From the Display menu use the UP (↑ ↑ ↑ ↑ ↑ ) or DOWN (↓ ↓ ↓ ↓ ↓ ) button to highlight Junction Temp and press the
ENTER button. The display will show the cold reference junction temperature in degrees Fahrenheit (°F)
(degrees Celsius [°C] if the time format is set to European).
NOTE: To have the Junction Temperature information come up automatically at power up and be the
default display, use the PROGram, Displays, Powerup disp option to set Junction Temp as the
Powerup display default. Refer to Section 5.4.3.
4.2.1.4 Version
This option displays the software version number in a pop-up window.
To display the version of software in your unit:
From the Display menu use the UP (↑ ↑ ↑ ↑ ↑ ) or DOWN (↓ ↓ ↓ ↓ ↓ ) button to highlight Version and press the ENTER
button. The version of software in your unit will be displayed. Press the OK? button to return to the
Display menu.
4.2.1.5 Media Status
This option displays the status of a disk/card in the Media Status Window
as shown in Figure 4-3.
To display the Media Status Window:
From the Display menu use the UP (↑ ↑ ↑ ↑ ↑ ) or DOWN (↓ ↓ ↓ ↓ ↓ ) button to highlight
Media Status and press the ENTER button. A window will be displayed
(similar to Figure 4-3) showing the total size of the disk, the amount of
free space available on the disk, the write protected status, the status
of the format, battery information and memory.
To remove the Media Status Window:
From the Display menu use the UP (↑ ↑ ↑ ↑ ↑ ) or DOWN (↓ ↓ ↓ ↓ ↓ ) button to highlight Media Status and then press the
ENTER button and the window will clear.
4.2.2 PROG (Program) Menu
The Program Menu allows the user to program inputs and associated parameters into the Recorder. Refer to
Chapter 5 of this Manual for complete programming details.
Artisan Scientific - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisan-scientific.com
Page 4-5
Total Size:
1,423 K
Free:
1,141 K
Write Prot:
NO
Format:
OK
Battery:
N/A
Memory:
1,024K
Figure 4-3
Media Status Window
Advertisement
Chapters
Table of Contents
