Omega RD8800 User Manual page 18

Chapter 2 Installation and Wiring
2.2.1.5 With the Recorder held firmly in place against the panel, install one of the locking bar assemblies
by sliding the locking bar notch into the slot on the side of the Recorder enclosure as shown in
Figure 2-3.
2.2.1.6 Using a slotted screwdriver, tighten the screw until the locking bar is just pressing against
the panel.
2.2.1.7 Install the other locking bar assembly into the slot on the opposite side of the Recorder enclosure
and tighten as before.
2.2.1.8 Using the screwdriver, tighten both screws so that the Recorder is held firmly in place. Do not
over tighten.
Artisan Scientific - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisan-scientific.com
Figure 2-3 Rear View Panel Installation
Page 2-4
Rear of Panel
Locking Bar Assembly
Screw