Table of Contents
Advertisement
This section describes the installation of the SNMP Solo
adapter when you connect it to the UPS and the network. (Refer
to the Configuration section for network communications'
setup.) For configuration, connect the SNMP Solo temporarily to
a PC with a terminal emulation package or to a dumb terminal.
The following steps guide you in connecting the SNMP Solo to
the network and UPS.
1. Install the UPS.
2. Adjust the DIP switches on
the
SNMP
Solo
Configuration. Switch 1 is
ON when down; switch 2 is
OFF when up.
3. Temporarily, connect the SNMP Solo
adapter to a dumb terminal or to a PC with
the terminal emulation package.
a) Using the configuration cable, connect the
end of the cabled labeled "SM-SER-117A"
into a dedicated RS-232 serial port on the
configuration PC.
b) Connect the other end into the SNMP
Solo's serial port.
4. Configure the communications settings.
a) Use the following settings to configure the dumb
terminal or PC.
Baud rate ! 9600
Data bits ! 8
! 1
Stop bit
! None
Parity
Initial Installation
for
Flow Control Xon/XOFF
Handshaking ! None
Terminal Type:! ANSI (VT100)
! Off
Local Echo
Initial Installation
Tripp Lite
9
Advertisement
Table of Contents
