Verify The Snmp Solo Operation; Figure 4 Communication Screen (Windows) - Tripp Lite SNMP Solo MT-SE-37/02 Owner's Manual

SNMP Solo
b) A Windows's communication screen with the typical
SNMP Solo setting:

Figure 4 Communication Screen (Windows)

5. Press OK if you have the Windows Communications
screen or accept your communication settings in the
terminal emulation package. The terminal is now
configured to communicate with the SNMP Solo
adapter.
6. Connect the power supply with the 9VDC connector to
the SNMP Solo adapter's power input. Connect the
other end of the power supply with a standard plug into
the UPS. Approximately five seconds after you supply
power, the adapter displays the introductory screen on
your terminal. Press <enter> to get to the main menu.
7. You are now ready to configure the SNMP Solo
adapter. Refer to the Configuration section for a
detailed discussion.
10 Initial Installation