Tripp Lite SNMP Solo MT-SE-37/02 Owner's Manual page 19

To assign the IP address of SNMP Solo, the gateway, and the
network, type at the prompt:
1, <space>, the IP address of the SNMP Solo, <space>,
MASK_BIT_COUNT, <space>, the IP address of the gateway.
The MASK_BIT_COUNT is used to indicate a mask for your
gateway. The meaning of the numbers used in the
MASK_BIT_COUNT will change based on the class of network
you have. A Class A network has 24 options, a class B network
has 16 options and a Class C has 8 options. The SNMP Solo
automatically discovers the type of network in use from the first
three digits of the IP address. The MASK_BIT_COUNT and the
corresponding mask for each type of network is shown below.
Class A Network
0 255.000.000.000
1 255.128.000.000
2 255.192.000.000
3 255.224.000.000
4 255.240.000.000
5 255.248.000.000
6 255.252.000.000
7 255.254.000.000
8 255.255.000.000
9 255.255.128.000
10 255.255.192.000
11 255.255.224.000
12 255.255.240.000
13 255.255.248.000
14 255.255.252.000
15 255.255.254.000
16 255.255.255.000
17 255.255.255.128
18 255.255.255.192
19 255.255.255.224
20 255.255.255.240
21 255.255.255.248
22 255.255.255.252
23 255.255.255.254
Configuration
Tripp Lite
13