Table of Contents
Advertisement
Your SNMP Solo monitors one UPS attached to an EtherNet
network using a Network Management Station. The complete
SNMP Solo package includes hardware and software, a UPS
cable, a power supply, a UPS Management Information Base
(MIB), and a manual.
SNMP Solo Features
The SNMP Solo hardware adapter runs an embedded Simple
Network Management Protocol (SNMP) software agent. This
agent responds to SNMP GETS and SETS and, also, forwards
traps to designated recipients when critical conditions occur to
the UPS—such as going on battery backup.
The SNMP Solo features:
•
Compact Size—A small unit that takes less space on your
work area. Dimensions are 4¾"x3½"(12 x 8½ cm).
•
One Serial Port—A DIP switch changes the adapter's
single serial port to a configuration port for installation or to
a communication port for normal operations.
•
Remote monitoring—Monitors utility power and low
battery status for one UPS from a remote workstation
(NMS).
•
Remote Control—Turns the UPS inverter off when the
NMS sends the proper command.
•
NMSs To Receive UPS Alarms—These traps (unsolicited
messages) inform you about the power condition of your
UPS.
•
Works with all major NMSs on EtherNet—SNMP Solo
works with the most widely used Network Management
Systems: HP Open View, Novell NMS, Sun NetManager,
IBM NetView, and many more.
Tripp Lite
Introduction
Introduction
1
Advertisement
Table of Contents
