Checking After Power-On; Displaying Boot Information - H3C SR6616 Installation Manual

Checking after power-on

After powering on the router, check the following items:
•
The LEDs on the front panel of the MPU are normal. For the LED description, see
•
The fans operate correctly, and you can hear fan rotating.
•
The configuration terminal displays information normally. You can see the startup window on
the local configuration terminal. For more information, see
•
After the power-on self-test (POST), the system prompts you to press Enter. When the
command line prompt appears, the router is ready to configure.

Displaying boot information

After power-on, the router initializes its memory, and then runs the extended BootWare. The
following information appears on the terminal screen:
System start booting...
Press Ctrl+D to access BASIC-BOOTWARE MENU
Press Ctrl+T to start memory test
Booting Normal Extend BootWare....
****************************************************************************
*
*
*
****************************************************************************
Copyright (c) 2004-2017 New H3C Technologies Co., Ltd.
Compiled Date
CPU Type
CPU L1 Cache
CPU Clock Speed
Memory Type
Memory Size
Memory Speed
BootWare Size
Flash Size
cfa0 Size
NVRAM Size
BASIC CPLD Version
EXTEND CPLD Version : 133.0
PCB Version
BootWare Validating...
Press Ctrl+B to enter extended boot menu...
NOTE:
• If the router is configured with two RPE-X1 MPUs in both slot 4 and slot 5, the router boots by
using the RPE-X1 MPU in slot 4 by default.
• If the router is configured with two RSE-X1 MPUs in both slot 5 and slot 6, the router boots by
using the RSE-X1 MPU in slot 5 by default.
H3C SR66 BootWare, Version 7.1.064
: Apr 6 2017
: MPC8548E
: 32KB
: 1000MHz
: DDR2 SDRAM
: 1024MB
: 400MHz
: 1024KB
: 4MB
: 495MB
: 128KB
: 134.0
: Ver.C
57
"Displaying boot information."
"MPU LEDs."
*
*
*