Running Belt Adjustment & Lubrication - LifeGear FLIP TRACK III 97276 Manual

RUNNING BELT ADJUSTMENT & LUBRICATION
GB
Running Belt Adjustment:
The running belt is adjusted at the factory; it may come loose during transportation and
from use. After prolong use of running, the belt will stretch out. If the running belt is
shifting to the left, turn on the main power switch of treadmill and let the running belt run at
the speed of 2-3 km/h. Using the hex key provided, turn the left rear roller adjustment bolt
1/4 turn in the clockwise direction. You should see the belt start to correct itself by moving
back toward the center. Repeat the above procedure until the running belt is centered. If
the running belt is shifting to the right, turn on the main power switch of treadmill and let
the running belt run at the speed of 2-3 km/h. Using the hex key provided, turn the right
rear roller adjustment bolt 1/4 turn in the clockwise direction. You should see the belt start
to correct itself by moving back toward the center. Repeat the above procedure until the
running belt is centered. If the running belt is slipping during use, turn off and unplugged
the treadmill. Using the hex key provided, turn both left and right rear roller adjustment
bolts 1/4 turn in the clockwise direction for the same distance, turn on the main power
switch of treadmill and let the running belt run at the speed of 2-3 km/h. You should now
walk on to the running belt to determine if the running belt is still slipping. Repeat the
above procedure until the running belt is not slipping.
Lubrication
The treadmill has already been spread with "Silicone Oil" in advance before leaving the
manufacturing plant. Silicone oil is without volatility and has gradually permeated through
the running belt. There will be no need to re-spread the oil in normal circumstances.
To maintain the running belt, we have included a small bottle of "Silicone Oil". "Silicone
Oil" may be re-spread once the resistance has been increased and the running belt starts
rubbing against the running deck. To hold open the running belt from two sides, apply the
silicone oil with an even motion on the center of the running deck. Allow the silicone oil to
'set' for one minute before using the treadmill.
Attention: Only use "Silicone Oil" lubricants for this equipment. In addition, do not add
any other oil ingredient; otherwise the treadmill will bedamaged. Do not
over- lubricate the walking board. Excess lubricant should be wiped off with a clean
towel.
38