Running Belt Adjustment - LifeGear Motion capture plus 97920 Owner's Manual

Lubrication
The treadmills have already been spread with "Silicone Oil" in advance before leaving the
manufacturing plant. Silicone oil is without volatility and has gradually permeated through the running
belt. There will be no need to re-spread the oil in normal circumstances.
To maintain the running belt, we have included a small bottle of "Silicone Oil". "Silicone Oil" may be
re-spread once the resistance has been increased and the running belt starts rubbing against the r
unning deck. To hold open the running belt from two sides, apply the silicone oil with an even motion
on the center of the running deck. Allow the silicone oil to 'set' for one minute before using the
treadmill.
Attention: Only use "Silicone Oil" lubricants for this equipment. In addition, do not add any other oil
ingredient; otherwise the treadmill will bedamaged. Do not over-lubricate the walking board.
Excess lubricant should be wiped off with a clean towel.

Running Belt Adjustment:

The running belt is adjusted at the factory; it may come loose during transportation and from use. After
prolong use of running, the belt will stretch out. If the running belt is shifting to the left, turn on the main
power switch of treadmill and let the running belt run at the speed of 2~3 km/h. Using the hex key
provided, turn the left rear roller adjustment bolt 1/4 turn in the clockwise direction. You should see the
belt start to correct itself by moving back toward the center. Repeat the above procedure until the
running belt is centered. If the running belt is shifting to the right, turn on the main power switch of
treadmill and let the running belt run at the speed of 2~3 km/h. Using the hex key provided, turn the
right rear roller adjustment bolt 1/4 turn in the clockwise direction. You should see the belt start to
correct itself by moving back toward the center. Repeat the above procedure until the running belt is
centered. If the running belt is slipping during use, turn off and unplugged the treadmill. Using the hex
key provided, turn both left and right rear roller adjustment bolts 1/4 turn in the clockwise direction for
the same distance, turn on the main power switch of treadmill and let the running belt run at the speed
of 2~3 km/h. You should now walk on to the running belt to determine if the running belt is still slipping.
Repeat the above procedure until the running belt is not slipping.
14