Running Belt Adjustment - LifeGear 97930 Owner's Manual

Lubrication
All the treadmills have been already spread with "Silicone Oil" in advance before the treadmill leaves the factory. Silicone oil is without
volatility and has gradually permeated through the running belt. There will be no need to re-spread the oil in normal circumstances.
To maintain the running belt, we have included a small bottle of "Silicone Oil". The "Silicone Oil" may be re-spread once the
resistance increases and the running belt rubs against the running deck or the equipment has been used for two years. To hold open
the running belt from two sides, apply the silicone oil with an even motion on the center of the running deck.
Attention: Only use "Silicone Oil" lubricants for this equipment. In addition, do not add any other oil ingredient; otherwise the
treadmill will be damaged.

Running Belt Adjustment:

After a long time of running, the belt will be stretched. You should turn the left and right bolts in the rear
roller clockwise direction at the same position until the running belt becomes tight.
The running belt is adjusted at the factory; it may become loose during transportation and from use.
Turn on the main power switch of treadmill and let the running belt run at the speed of 4~5 km/h before
adjusting, and then adjust the left and right bolts in the rear roller with the hexagon wrench. It is better
to adjust 1/2 circle at once. To make the running belt moves to the right, turn the left bolt 1/2 circle in
the clockwise direction. To make the running belt moves to the left, turn the right bolt 1/2 circle in the
clockwise direction.
14