Table of Contents
Advertisement
Model W1842 (For Machines Mfd. Since 6/17)
Table.Height.Chain.&.Sprockets
Lube Type ...................................NLGI#2 Equivalent
Sprockets
Amount ................................................ Thin Coat
Frequency ..................... Every 160 Hours of Operation
The table leadscrews are synchronized by the table height
chain and sprockets located underneath the planer base
(see Figure.42). To access the table height chain, it will
be necessary to remove the planer/moulder unit from
Chain
the cabinet and then to re-install it afterwards. (Refer to
Page.49 for further details.) Use shop rags and mineral
Figure.42. Table height chain and
spirits to clean away debris and grime, then brush on
sprockets (cabinet removed for access).
a light coat of multi-purpose grease to the chain and
sprockets.
Drive.Chain.&.Sprockets
Drive
Lube Type ...................................NLGI#2 Equivalent
Chain
Amount ................................................ Thin Coat
Frequency ..................... Every 160 Hours of Operation
The infeed and outfeed rollers receive the transferred
power from the cutterhead through the drive chain
system on the right side of the machine, as shown in
Figure.43.
Remove the gear cover and drive chain covers to access
Sprockets
these parts.
Figure.43. Location of drive chains and
Use mineral spirits and shop rags to clean away any debris
sprockets.
and grime, then brush on a light coat of multi-purpose
grease to the chain and sprockets.
-45-
Advertisement
Table of Contents
