Table of Contents
Advertisement
Model W1842 (For Machines Mfd. Since 6/17)
4. Slide dust hood under chip guard bracket and secure
top with (3) M5-.8 x 8 cap screws and (3) 5mm
lock washers and secure bottom with (1) M6-1 x 12
cap screw and (1) 6mm lock washer, as shown in
Figure.13.
5. Attach handwheel handle to handwheel, then place
handwheel over shaft shown in Figure.14, and
rotate handwheel until pin in shaft slides into groove
in handwheel.
6. Attach (1) 9mm E-clip to notch on one end of knife-
setting shaft (see Figure.15).
7. Slide cast-aluminum knife-setting jig feet onto shaft
(see Figure.15) and slide each to an end.
8.. Attach (1) 9mm E-clip to notch at other end of
shaft, then attach (2) 9mm E-clips (see Figure 15) to
interior notches to secure feet.
Figure.13. Dust hood installed.
Handwheel
Shaft
Figure.14. Installing handwheel.
E-Clips
Figure.15. Knife-setting jig assembled.
-19-
x 3
x 1
Dust Hood
Handle
Groove
Pin
E-Clips
Shaft
Feet
Advertisement
Table of Contents
