Table of Contents
Advertisement
Model W1842 (For Machines Mfd. Since 6/17)
Bedboard
A bedboard is essential to prevent the moulding knives
from coming into contact with the work table and
damaging the moulding knives, cutterhead, and work
table.
Components.and.Hardware.Needed:.
⁄
" to
⁄
" Plywood or MDF (Not included) .................1
1
1
4
2
⁄
" Screws (Not included) .....................................4
1
2
⁄
" Washers (Not included) ...................................4
1
2
Tools.Needed:
Screwdriver ......................................................1
Saw (Not included) .............................................1
Hex Wrench 5mm ...............................................1
To.install.bedboard,.do.these.steps:
1. DISCONNECT MACHINE FROM POWER!
2. Cut
⁄
" -
⁄
" thick plywood or MDF that has a
1
1
4
2
smooth surface to 13"W x 17
3. Center bedboard on work table. Fasten bedboard
to work table from underneath through pre-drilled
holes with screws and washers.
4. Loosen fence rod brackets shown in Figure.29 and
slide brackets up. Finger tighten cap screws.
5. Install moulding fences (see Figure.29).
6. Adjust fence rod brackets until moulding fences lie
flat on surface of bedboard (see Figure.29) and
tighten fence rod bracket cap screws.
Qty
⁄
"L.
3
4
-33-
Bedboard
Moulding
Fence
Clamping
Block
Figure.29. Location of fence rod bracket.
Fence
Rod
Bracket
(1 of 2)
Advertisement
Table of Contents
