Table of Contents
Advertisement
Model W1842 (For Machines Mfd. Since 6/17)
Voltage.Conversion.to.
The voltage conversion MUST be performed by an
electrician or qualified service personnel.
The voltage conversion procedure consists of rewiring the
motor and installing the correct plug. A wiring diagram is
provided on Page.58 for your reference.
IMPORTANT: If the diagram included on the motor
conflicts with the one on Page 58, the motor may have
changed since the manual was printed. Use the diagram
provided on the motor junction box instead.
Items.Needed.
•
Phillips Head Screwdriver #2 ............................1
•
Electrical Tape ................................. As Needed
•
Wire Nut (14 AWG x 3) ....................................1
•
6-15 Plug ....................................................1
•
Wire Cutters/Stripper.....................................1
To.convert.Model.W1842.to.220V,.do.these.steps:
1.. DISCONNECT MACHINE FROM POWER!
2. Cut off existing 5-15 plug.
3.. Remove front cabinet cover and motor junction box,
remove two wire nuts indicated in Figure.5,.then
disconnect wires.
4. Use wire nuts to connect wires as indicated in
Figure.6. Twist wire nuts onto their respective wires
and wrap them with electrical tape so they will not
come loose.
5. Close and secure motor junction box.
6.. Install a 6-15 plug according to manufacturer's
instructions. If plug manufacturer's instructions are
not available, NEMA standard 6-15 plug wiring is
provided on Page.58.
220V
Remove
Wire
Nuts and
Disconnect
Wires
To Switch
Qty
Figure.5. Inside motor junction box (motor
pre-wired to 120V).
Connect Wires
and Secure
with Nuts
Figure.6. Motor rewired to 220V.
-13-
Ground
MOTOR 110V
Ground
Rewired to 220V
Ground
Sta
Capa
300
125V
Sta
Capa
300
125
Advertisement
Table of Contents
