Table of Contents
Advertisement
Model W1842 (For Machines Mfd. Since 6/17)
Crown.Moulding.Support
When cutting crown moulding (see Figure 36), make a
CORRECT
wooden V-track that can be clamped to the table. The
V-track must support at least 50% of the workpiece height
on both sides.
V-Track
DO NOT use the guide rails that came with your machine
for crown moulding support. If you do, the workpiece can
dislodge and be ejected from the machine, causing severe
injury or damage.
INCORRECT
Figure.36. Example of crown moulding
V-Track.
Appropriate.Workpiece.Size
CORRECT
Make sure to cut your workpiece to the correct width for
the knife being used (see Figure 37). To improve knife life
and workpiece results when cutting in very hard woods,
use a table saw to rabbet out some of the profile before
running the workpiece through the planer/moulder.
Never cut into moulding that is wider than the knife.
Otherwise, the knife will overheat, burn the wood, and
dull rapidly.
INCORRECT
Figure.37. Correct workpiece sizing.
-39-
Advertisement
Table of Contents
