Table of Contents
Advertisement
Connecting to the High/Off Pin will remove all power from the
vehicle until the Off-Peak Charging time arrives. The correct Pin
can be identified using the wiring diagram for the CS 3-Phase on
page 17 of this manual. The other two pins on the terminal block are
the relay contacts for the External Indicator.
In summary, making the best use of the Maintenance Current
feature will require the following:
1. Installation of a Time-Of-Use meter by the electric
utility.
2. Installation of a clock/timer to allow the CS 3-Phase to
charge only during Off-Peak hours.
3. Connecting the timer's control wire to the High/Low
Pin on the Terminal Block.
CS 3-Phase Installation Manual
Page 11
Advertisement
Table of Contents
