Parker 506 Product Manual page 4

WWW.SDS.LTD.UK | 0117 9381800
Safety Information
WARNING! - Ignoring the following may result in injury or damage
to equipment
Where there is conflict between EMC and Safety requirements, personnel safety
• Never perform high voltage resistance
checks on the wiring without first
disconnecting the drive from the circuit
being tested.
• Whilst ensuring ventilation is sufficient,
provide guarding and /or additional
safety systems to prevent injury or
damage to equipment.
• When replacing a drive in an
application and before returning to use,
it is essential that all user defined
parameters for the product's operation
are correctly installed.
• In a domestic environment this product
may cause radio interference in which
case supplementary mitigation
measures may be required.
This equipment contains electrostatic
•
discharge (ESD) sensitive parts.
Observe static control precautions when
handling, installing and servicing this
product.
SAFETY
shall always take precedence.
• All control and signal terminals are
• Thermal sensors contained within the
• All exposed metalwork in the Inverter
• RCDs are not recommended for use
EMC
•
SELV, i.e. protected by double
insulation. Ensure all external wiring
is rated for the highest system
voltage.
motor must have at least basic
insulation.
is protected by basic insulation and
bonded to a safety earth.
with this product but, where their use
is mandatory, only Type B RCDs
should be used.
This is a product of the restricted
sales distribution class according to
IEC 61800-3. It is designated as
"professional equipment" as defined
in
EN61000-3-2. Permission of the
supply authority shall be obtained
before connection to the low voltage
supply.
!