Concluding Work And Coding - BMW 65 50 0 418 002 Installation Instructions Manual

20. Concluding work and coding

For cars with SA6FL only (USB/audio interface)
To play ACM audio through the car's speakers, no device can be connected to the USB interface.
Cars without AUX socket only
This retrofit system requires coding.
- Connect the battery
- Conduct a brief test
- Program/encode the retrofit with SSS (Software Service Station) via the CIP, AUX IN connection retrofit path
Cars with AUX jack only
This retrofit system does not require coding.
- Connect the battery
- Conduct a brief test
Make settings in the ACM Service Menu for all cars
The systems installed in the car must be selected in the ACM Service Menu.
Systems that are not selected are skipped when scrolling or are hidden from the customer.
To call up the ACM Service Menu:
- Press and hold the "Menu" button to bring up the accessory menu
- Move the controller once to the right
- Move the controller 3 times to the left
- Press controller once
The ACM Service Menu is displayed on the control display.
By turning and pressing the controller, you can now select or disable systems that have or have not been installed.
Selected and unselected systems are shown in SW.
Selectable systems are shown in WS.
For cars with ACM software version older than C23i05V1 only
For cars with CCC, the ACM unit C may need to be initialised after installation, repair or software update of the car.
If picture interference occurs, proceed as follows:
- Disconnect branch A15, BL 26-pin, on the ACM unit C and disconnect cable from PIN 12
- Reconnect branch A15 and switch on the ignition, the displayed image is now shifted by approx. 1/3 of
the screen
- Switch off the ignition
- Disconnect branch A15 and reconnect the previously disconnected cable to PIN 12
- Connect branch A15 to the ACM unit C and switch on the ignition
The initialisation is complete.
© BMW AG, Munich 01 29 0 420 167 12/2007 (Z/Z) 37