Replace Fuse - AMP Research POWERSTEP 76141-01A Installation Manual

OBD II install: Use Supplied Posi Twist connectors to attach the Plug and Play Module to the
Harness. Attach matching colors on the harness to the wires on the module. Plug in module to
OBD II port on the vehicle. Secure harness with supplied tie wraps.
Note: If the OBD II pass thru harness (76404-01A) was purchased see install sheet supplied in packaging.
The pass through harness allows for an open port for other accessories. See below for a brief description.
To Vehicle
Power (12V)
To Powerstep
Motors
To Powerstep
Motors
To Vehicle
Power (12V)
To Powerstep
Motors
To Powerstep
Motors
12 14 11

Replace fuse.

16 12
www.amp-research.com www.amp-research.com
A M P R E S E A R C H P O W E R S T E P
Powerstep
Control Module
To Vehicle
Power (12V)
Powerstep
Control Module
To Vehicle
Power (12V)
Powerstep
Powerstep
Connection Module
Connection Module
4
– F O R D F - 1 5 0
T M
Powerstep
Control Module
Connection Module
Powerstep
Connection Module
13
Pass-Through Harness Option
Powerstep
Control Module Vehicle Port
Vehicle Port
Vehicle Port
Pass-Through Harness
Vehicle Port
(pin-to-pin at each terminal)
Pass-Through Harness
(pin-topin at each terminal)
2
Open doors to extend drive linkage
assembly (if not already extended).
13
7/9 7/9
Vehicle Port
Vehicle Port
Powerstep
Direct to Port Option
Direct to Port Option
Pass-Through Harness Option
New Vehicle Port
(replaces original port) New Vehicle Port
(replaces original port)
3
IM76141 rev 01.20.20