Placing Ladder In Pool - Confer Plastics ROLL-GUARD 7200 Assembly And Installation Manual

STEP 5:

PLACING LADDER IN POOL

CHOOSE A LOCATION THAT IS LEVEL AND IN FULL VIEW. POOL MUST HAVE
COMPETENT ADULT SUPERVISION AT ALL TIMES WHEN IN USE.
#1: With roll-guard in closed
position, carefully lift the
inside ladder section over
the pool wall.
#4: With ladder in place and
sitting on pool bottom, place
one of the adjustable braces
on the side of ladder so it is
resting on the pool top seat.
Secure the adjustable brace
to the ladder rails using 2-
#10 x 1-1/4" self tapping
screws. Repeat for the
second brace.
Tools needed:
Parts needed:
Fill rails with water
using garden hose
#2: Using garden hose, fill
all 4 rails with water through
the openings and cap when
full. As the rails are being
filled, the ladder will start
to sink.
#5: Using the braces as
locators, drill two 1/4" holes
through the pool top seat
being careful not to damage
pool wall or liner. Fasten
ladder to the pool using
2-1/4-20 x 3-1/2" screws,
washers, and hex nuts.
#7: To open pool ladder,
remove the lock and pull
locking tab out. Lift up on the
roll-guard and slide around to
the inside of pool ladder, push
locking tab back in and lock.
WHEN POOL IS
IN USE, THE
ROLL-GUARD
MUST REMAIN
ON INSIDE OF
POOL AND
LOCKED. THE
ROLL GUARD
WILL PREVENT SWIMMING
THROUGH INSIDE LADDER
TREADS.
garden hose, cordless drill w/Phillips driver
1/4" drill bit, Phillips screwdriver, pliers
4- cap plugs
2- adjustable braces
2- 1/4-20 x 3-1/2" bolts, washers and hex nuts
1- Padlock
#3: Tilt the ladder from "side
to side" to get all the air out
of treads. As the treads fill
with water, the ladder will
continue to sink, this may
take several minutes.
#6: The ladder is in the
closed position when the
roll-guard is pulled down
covering the outside ladder
treads. To lock, push in the
roll guard locking tab located
on the left bridge. When
properly locked, the roll-guard
will not lift up. Install the
padlock through the locking
tab hole.
WHEN POOL IS NOT IN
USE THE ROLL-GUARD
MUST BE IN CLOSED
POSITION AND LOCKED.
Optional lock
location
(if needed).