IDTECK 100R Quick Installation Manual page 14

8.4 Exit Button Connection
Connect one of the wires of Exit Button to Exit Button Input, Orange wire.
●
Connect the other wire of Exit Button to Power GND (-) wire.
●
(If a normally closed Exit button is used, then see section 12-55 to change the detection
scheme from the defaulted setting)
8.5 Door Contact Sensor Connection
Connect Door Contact sensor (COM) wire to Door Contact Input, Yellow with Red stripe wire.
●
Connect Door Contact sensor (NO) wire to Power GND (-) wire.
●
(If a normally closed Door Contact sensor is used, then see section 12-57 to change the detection
scheme from the defaulted setting.)
8.6 Auxiliary Input Device Connection (Applied to AUX Input #1, #2, #3)
Connect one wire of the Auxiliary Input Device to the AUX Input wire
●
(Input *1 Green, Input *2 Green with White stripe, Input *3 Green with Red stripe wire).
Connect the other wire of Auxiliary Input Device to Power GND (-) wire.
●
(If a normally closed input device is used, then see section 12-49, 51 & 53 to change the
detection schemes from the defaulted settings.)
Continued on next page.
Quick Installation Guide
14