Advertisement
Installation instructions, accessories
Volvo Car Corporation Gothenburg, Sweden
47
© Volvo Car Corporation
Connect the green female connector on the new cable harness
to the green male connector disconnected from the radio
Connect the other two large connectors to the radio
Connect the DIN cable to the DVD unit
Connect the remaining connectors which were disconnected
from the radio
Connect the connectors to the dashboard environment panel
Connect the connectors to the phone keypad if applicable
Reinstall the radio and dashboard environment panel in the
centre console. Tighten using the two screws
Reinstall the panel and gear selector lever boot around the gear
selector lever
Fold the carpet back into place
Reinstall the side panel on the centre console
Reinstall the sill trim panels on the left-hand side
Fold the left-hand front seat back into position
Tighten the front edge of the seat. Tighten the seat using the two
new screws from the kit. Tighten to 40 Nm (30 lbf ft) . Reinstall
the covers over the screws
Reinstall the parcel shelf
Reinstall the C-post panels. Press the rubber mouldings into
position
Reinstall the front side panel in the cargo compartment
Connect the cargo compartment lighting connectors to the
tailgate sill trim panel. Reinstall the sill trim panel
Install a new left-hand folding panel from the kit. Reinstall the
right-hand panel
Reinstall the side cushion
Fold the backrest back into place
Fold the seat cushion back into place.
Installing, keypad in the steering wheel
Navigation system (RTI)- 30660446 - V1.0
Page 30 / 35
Advertisement
