Advertisement
Installation instructions, accessories
Volvo Car Corporation Gothenburg, Sweden
25
D3703372
26
M3703400
© Volvo Car Corporation
Cable routing
Route the wiring for the display screen and the radio (A in the kit
illustration), and the DIN wiring for the radio (B in the kit
illustration) between the air duct (1) and the stay (2)
Route the cable ends, with the blue 5-pin connector (3) for the
power supply and the grey angled connector (4) for the display
screen to the left of the air ducts above the cut-out for the radio
to the cut-out for the dashboard loudspeaker
Clamp the wiring to the stay (2). Use the tie strap (5) from the kit
Route the wiring above and along the air duct (1) to the member
(6)
Secure the wiring at the existing cable harness (7). Use the tie
strap from the kit.
Route both cables (A and B in the kit illustration) under the
carpet. Continue along the left-hand side of the car to the rear
door
Install the protective caps on the lugs (1) for the cable ducts
Route the wiring further above and along the front cable duct (2).
Continue along the right-hand side of the rear cable duct (3).
Navigation system (RTI)- 30660446 - V1.0
Page 19 / 35
Advertisement
