Advertisement
Installation instructions, accessories
Volvo Car Corporation Gothenburg, Sweden
52A
M3903760
52B
M3903761
53
M3903762
© Volvo Car Corporation
Illustration A
Place the steering wheel in a suitable position. Cut along the
existing markings. Use a small knife.
Note!
Hold the knife so that the cut is made at right angles to the
reverse of the steering wheel. This is to reduce the risk of
cutting too large a hole as the edge around the keypad is only
a few millimetres wider than the keypad itself.
Illustration B
Also cut off a section of material on the reverse of the steering
wheel spoke
Cut until the keypad is positioned properly.
Take the keypad, two screws and the cover from the kit
Ensure that the cable is positioned on the underside of the
steering wheel spoke
Insert the keypad in the hole in the steering wheel with the text
on the buttons facing upwards. Press inwards until the keypad
lies flush with the steering wheel cover.
Navigation system (RTI)- 30660446 - V1.0
Page 33 / 35
Advertisement
