Download Print this page
Volvo 2008 V50 Installation Instructions, Accessories
Hide thumbs Also See for 2008 V50:

Advertisement

Accessories
Installation instructions
C30
C70
V50 2008
1.8F, Manual, L.H.D
Sweden
User guides
Global collection
S40
S60
S80
V40
Installation instructions, accessories
Volvo Car Corporation Gothenburg, Sweden
Instruction No
Version
Part. No.
30732784
1.2
31285189, 30732782
Equipment
A0000162
A0000161
English
V40
V50
V50
V60
Cross
Country
Navigation system, RTI
A0801912
A0801178
V70
XC60
XC70
Find a dealer
Other models
XC90
Wish list (0)
V50 2008
V50, 2008

Advertisement

loading
Need help?

Need help?

Do you have a question about the 2008 V50 and is the answer not in the manual?

Questions and answers

Summary of Contents for Volvo 2008 V50

  • Page 1 Other models XC60 XC70 XC90 Cross Country Wish list (0) V50 2008 Installation instructions, accessories V50 2008 1.8F, Manual, L.H.D Volvo Car Corporation Gothenburg, Sweden V50, 2008 Sweden Instruction No Version Part. No. 30732784 31285189, 30732782 Navigation system, RTI Equipment A0000162...
  • Page 2 Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps. In the event of any problems with the instructions or the accessory, contact your local Volvo dealer. Note! This accessory requires software unique to the car.
  • Page 3 Wait at least five minutes before disassembling the connectors or removing other electrical equipment. A8800136 Illustration A Remove the loudspeaker grille as follows: Insert the tool, Volvo part no. 999-5919-46 into the joint between the loudspeaker grille and the dashboard approximately as illustrated, until it engages.
  • Page 4 J3905155 Installing the screen Connect the pre-routed blue connector (1) and the pre-routed DIN cable (2) (in the cut-out in the dashboard) to the screen from the kit. Note! Route the cable with the green connector (3) so that it comes out in front of the screen.
  • Page 5 Press the grille into the hole so that all hooks engage. J3905134 Installing the DVD reader. Remove the panel on the right-hand end of the dashboard by carefully prying it loose all around with a weatherstrip tool, until the three clips release. Note! Do not damage the dashboard.
  • Page 6 J8803088 Remove the glove compartment front section. Pull it back until the two clips in the upper edge release, following which, detach the three connectors on the upper side. J8803119 Remove the screw to the air vent on the right-hand side. Pull it away from the connection and lay it aside.
  • Page 7 J8504871 Detach the sill moulding at the front edge of the right-hand front door. Fold aside the floor carpet and remove the clip on the right-hand side, under the impact member, in order to access the foam covered connectors taped at the existing cable harness. Remove the cables from the tape and remove the foam covers (2) and (3).
  • Page 8 J3904813 Applies to the S40 Applies to the S40 Cargo compartment preparations Remove the cargo compartment carpet. J8504553 Remove the upper floor supports on the right and left-hand sides if applicable. J8504625 Unscrew the two external clips at the front edge/bottom edge of the sill trim panel on the tailgate.
  • Page 9 eyelet. Fold out the side panel so that the amplifier at the rear of the wheel arch is accessible. J8504690 Remove the three nuts holding the amplifier to the body. Remove the amplifier, and disconnect the front connector from the fibre optic cables. J3904584 Applies to the V50 Applies to the V50...
  • Page 10 J8504621 Grasp the upper edge of the left-hand side cushion (1). Pull the side cushion forward so that the clip on the reverse releases. Slide the side cushion upwards. Remove the screw at the rear edge of the panel (2) at the front/top of the left-hand side panel.
  • Page 11 J8504639 Remove the three nuts holding the amplifier to the body. Remove the amplifier. Disconnect the front connector from the fibre optic cables. J3904790 Applies to the S40 and V50 Applies to the S40 and V50 Installing the global positioning system module (GPS) Illustration A Take the GPS control module, bracket, screws and washers from the kit.
  • Page 12 J3904634 Reinstall the amplifier on the studs. Install and tighten the three nuts. Tighten to 10 Nm (7.5 lbf.ft.). Take the pre-routed antenna cable secured with a clip at position (1) below the amplifier. Detach the power cable which is secured with tape at the antenna cable.
  • Page 13 J8504749 Remove the parcel shelf panel by first detaching it from the two brackets on the underside, on the right and left-hand sides. Pull its front edge up until the two clips on the underside release and the two guide pins have come out from their holes. Pull the panel forward and place it on the folded backrests.
  • Page 14 J3905359 Applies to the V50, European market only Applies to the V50, European market only Installing the traffic message channel module (TMC) Grasp the upper edge of the right-hand side cushion (1). Pull the side cushion forward so that the clip on the reverse releases. Slide the side cushion upwards.
  • Page 15: Finishing Work

    Reinstall the rubber strip in the tailgate opening. Reinstall the sill trim panel in the tailgate opening. Reinstall the upper floor supports if applicable. Reinstall the cargo compartment carpet. Reconnect the battery negative lead. Programme the software. © Volvo Car Corporation Navigation system, RTI- 30732784 - V1.2...
  • Page 16 Country & language Copyright Legal disclaimer Privacy policy Print...