Advertisement
Installation instructions, accessories
Volvo Car Corporation Gothenburg, Sweden
37
M3903315
38
M3903788
© Volvo Car Corporation
Installing the DVD reader
Does not apply to USA/AUS
Remove the existing antenna amplifier (if applicable)
Connect the cable (2) for the new antenna amplifier (1) to the
connector (3) for the antenna in the rear bumper by the right-
hand tail lamp
Position the antenna amplifier on the panel edge in front of the
right-hand tail lamp
Tighten the antenna amplifier onto the edge of the panel.
Does not apply to USA/AUS
Route the new transparent single cable (D in the kit illustration)
from the lower terminal (1) for the aerial amplifier, along the
existing cable harness in the rear crossmember and to the rear
edge of the left-hand rear wheel well
Clamp the cable at the existing cable harness using tie straps
(2)
If the existing aerial amplifier has been removed, reinstall the
disconnected black cable in the upper socket (3) in the aerial
amplifier.
Navigation system (RTI)- 30660446 - V1.0
Page 25 / 35
Advertisement
