Basic Operation Mode - Opticon NLV-5201 Specification Manual

NLV-5201 Specifications Manual
NLV-5201 Components
Callout Name
1 Scan Window
2 Mounting Holes
3 Control Panel
4 Buzzer Holes
5 Status LED
6 Trigger Key
7 Mode Key

5 Basic Operation Mode

Make sure you understand the symbols used to indicate the states of the status LED indicator.
Symbol Description
OFF
Blinking
ON
4
Description
Light paths of the imager scanner, LED illumination, and aiming. Make
sure that the lens is free from dust and dirt before scanning. For more
"Cleaning the NLV-5201" on page
information, see
Screw holes (two on the bottom and two on the side) that you can use to
mount the imager scanner. 2 holes on the bottom and side. For the
mounting hole dimensions, see
Use the control panel to run Test mode, Tune mode, and Aim mode. You
can also select the bank. For more information, see
Operation Specifications" on page
Sound from a built-in buzzer comes out through these holes. When the
holes are covered, the buzzer sound is diminished. The sound varies
depending on the settings. You can configure the frequency, loudness,
and duration of the buzzer.
Indicates status with 3-color LEDs: red, orange, and green. For more
"LED Indicator Specifications" on page
information, see
The default key is the trigger key. When you select a mode from the
control panel, the trigger key operates as an execution key.
Use the mode key to select and cancel the mode. Press and hold the
mode key to return to saved settings bank select mode.
37.
"Mechanical Drawing" on page
"Control Panel
7.
41.
8.