Stopping The Engine; Operating The Tractor - Kioti DK65 Manual

7.1.3 Stopping the Engine

Reduce engine revolution and apply even foot pres-
sure on both brake pedals. Depress the clutch pedal
and place main gear shift lever and PTO switch in Neu-
tral. Lower equipment. Allow engine to idle for a short
time before turning it off. Stopping a hot engine at high
speed may cause internal engine damage. Set the
parking brake by pulling the lever up. Turn main key
switch counterclockwise to the "OFF" position to open
electric circuit.
IMPORTANT :
• Remove the key whenever you leave the tractor,
then you are certain the ignition and lights are off.
Also, it prevents unauthorized operators from start-
ing the tractor.
• After operating the tractor or engine,
never touch the muffler on the heat
shield until it has sufficient time to cool.
WARNING

7.2 Operating the Tractor

Pre-operation Inspection
Before starting, make a routine inspection of the trac-
tor as outlined in the maintenance check-list (p54).
Always allow engine to warm up before applying load.
Selection Travel Speed
Depress clutch pedal, and shift the main shift lever
and the range lever to the desired speed.
Adjusting Throttle Position
Always operate power-drive equipment such as rotary
mower, snow thrower, rotary tiller, etc. at 540 PTO rpm
mark unless otherwise specified in the equipment
owner's manual.
Use shift lever to select a safe travel speed. Proper
travel speed will depend first on the type of equipment
used on the tractor and second, on field, garden or
yard conditions.
- 45 -